South West Bikers | Motorcycle Forum

deej wrote:can you not put long nuts and bolts in through the ply and floorpan, thats what i did in my old T4. will make it more secure than few screws that could pull out of the ply

Well yeah I could, but man, thats hassle, got to take the ply up and everything. Wanna come round and do it for me

umm no ta

did mine in the snow and it wasnt fun crawling under the T4 to fit them

No snow now

Going to go chop the seating arrangements around a bit now, put a single seat in the front, and cut some of the 1/2 bulkhead out, so the surfboards will fit in lying down

Wire in the stereo and give it all a good clean out, got sleeping arrangements sorted for track days n all, but not sure if it will work yet

good man, stick some shelfs in up above where the bikes would go too

So spent all morning [Censored] about, acheived- removing ply half bulkhead, fitting radio, clean out . Bloody single seat wont fit without drilling the floor, and I only stand to gain 6" width so left it with the two.

Run some notched timber rails along the sides about 8 - 12" above the top of the bike, sling some scaffold tubes between them across the van with some 1" ply over, and instant trackday bed

Yeah I would do but I'm not sure how much height I will have above the bikes free.

look here

http://www.v2mal.co.uk/v2mal/product/58

and here

http://www.v2mal.co.uk/v2mal/category/36

Er, ok. Or I can save myself some money and just do it the normal way