Page 3 of 3
Re: Deposit down! ZXR400 :)
Posted: Mar 22nd, '09, 18:43
by Johnnyb
Or three bikes dented in identical places, maybe its a design fault in that bike...............

Re: Deposit down! ZXR400 :)
Posted: Mar 22nd, '09, 19:49
by Milky
Johnnyb wrote:Or three bikes dented in identical places, maybe its a design fault in that bike...............

shhh! it's not!

Re: Deposit down! ZXR400 :)
Posted: Mar 22nd, '09, 20:48
by badgerKDD
Do any of your mates have a Full driving license, if so borrow a van ( or hire if they are old enough) and go get it!
Re: Deposit down! ZXR400 :)
Posted: Mar 22nd, '09, 23:20
by Milky
badgerKDD wrote:Do any of your mates have a Full driving license, if so borrow a van ( or hire if they are old enough) and go get it!
yehh.. 'delvey91' has a van and has kindly offered.. and also two of me mate's dad's have vans that i could borrow for the day so pretty sorted

Re: Deposit down! ZXR400 :)
Posted: Mar 23rd, '09, 00:10
by TLS-Moose
On most "fabricated" ally frames, a dent or scrape on the side of the beam isn't the end of the world ....... you don't throw a car away just got it has a dent in the wing, do you
Depending on the depth of the dent/scar, you can weld a little tab in the centre of the impact and pull it out a bit with a slide hammer, then fill whats left with ally weld and grind and polish or paint so it's invisible

Done this a couple of times with no problems at all
If the dent/crease is up around the headstock, it's a different story, and you have to play very carefull ..... some bikes (R1's) are notoriously weak in this area ......
Another thing to watch on ally frames with frontal impacts, especially on bikes with USD forks, is that the steering bearing seats (and fork legs around the seals) can become ovalled, and it'll always cause problems thereafter ....

Re: Deposit down! ZXR400 :)
Posted: Mar 23rd, '09, 00:39
by BladeMan
Nice bike M8 i had one about 10 years ago. I hope to get another one day.

Re: Deposit down! ZXR400 :)
Posted: Mar 23rd, '09, 06:55
by Stately
Check out the way the fairing panel is way off in the 6th photo.
It's not even close to mating up with the upper fairing.
I'd want that panel off and have a good look underneath at the mounting points.
That's the only trouble with fairings.
They can hide a multitude of sins.
Re: Deposit down! ZXR400 :)
Posted: Mar 27th, '09, 02:18
by Varcon
Funky..im not sure if the frame is bent...just looks like the lighting ?
Nice bike mate, will look good with a bit of money spent on it, ideal timing for the summer ! Was gonna say give me a bell when you pick it up and ill ride down with you as trowbridge is very close...but as your not riding it that might be hard !