Hydraulic lifting thingy

tdmwicky · Post by **tdmwicky** » Jul 10th, '07, 19:50

Hello i'm desperate to borrow one of these so i can elevate and enjun into position !! I'll leave a full deposit with anyone who can loan me one and i'll bung em' some beer tokens in return. I'd even collect tonight if possible. Do i sound desperate enuf !!!??? I'm in Silverton near Exeter so if anyone in the area (Torbay, Taunton etc) can help me out that'd be ab fab.

tanks WiCkY, woops a link would help !

http://www.busters-accessories.co.uk/pr ... od=MMPSHYH

Post by **TLS-Moose** » Jul 10th, '07, 22:26

Not got one of them, but I've got a hydraulic trolly jack you can borrow

tdmwicky · Post by **tdmwicky** » Jul 10th, '07, 22:33

cheers Moose but i have one of them, i need the udder yoke as the enjun will topple over on a stock trolly jack and i don't wanna hole an enjun case !!!!!!!

Post by **TLS-Moose** » Jul 10th, '07, 22:34

Hokey dokey, no worries

tdmwicky · Post by **tdmwicky** » Jul 11th, '07, 08:38

Bump, Bump, Bump !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! only need it fer 24 hours !!

speedy(delboy) · Post by **speedy(delboy)** » Jul 11th, '07, 16:49

tdmwicky wrote:Bump, Bump, Bump !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! only need it fer 24 hours !!

Got a full blown bike lift, but I'm in Barnstaple

tdmwicky · Post by **tdmwicky** » Jul 11th, '07, 19:59

Moose, Speedy and udders, tank ye all kindly fer the offers but i managed to fabricate a plate to attach to the trolly jack and it worked !! just gotta plumb it all back together now and hopefully hey presto !! regards Wicky

baskie · Post by **baskie** » Jul 11th, '07, 21:12

tdmwicky wrote:Moose, Speedy and udders, tank ye all kindly fer the offers but i managed to fabricate a plate to attach to the trolly jack and it worked !! just gotta plumb it all back together now and hopefully hey presto !! regards Wicky

good effort, job well done mate ;)

tdmwicky · Post by **tdmwicky** » Jul 12th, '07, 10:20

Cheers Baskie.

i cleaned up and resprayed the front of the block, clearances checked and all ok as only done 6k !!, manually oiled the bores and cams etc and turned her over be hand afore fitting just to help prevent enjun wear as she ain't been run ferra few months. fingers crossed she'll purr inta life later on and oil tek her out tonoight to a bike meet in Seaton.

baskie · Post by **baskie** » Jul 12th, '07, 11:26

sweet mate. we recebntly just done the same to my mate KLE 500, we just stripped it down. laid it on some carpet and whiped out the engine. gettign all sprayed and what not and will look amazing. looking good though mate. good effort.