South West Bikers | Motorcycle Forum

Bought an LED tail light with intergrated indicators for the bike.

It came with no instructions at all....Great!

The brake light is just plug and play so thats alright....But there are only 2 wires coming out the back for the indicators. A yellow and a blue one. Surley there should be 4??

Also what resistors should i get?

A picture.........

i would say contact the manufacturers and ask them to email you some instructions

No wories ive figured it out now. Just need to wire in some load resistors.

taken a communial earth from the light plug and then yellow -right, blue -left type of thing ?

they do look good , but when you finally come to the MOT, it will fail.....

Well all that comes out of the back of light is a blue and yellow cable, Plugged each of these into the positives that went to the old indis and it works fine.

And my MOT isnt until next July so got plenty of time until i have to faf abaout changing it

A video of it fitted....

delvey91 wrote:Well all that comes out of the back of light is a blue and yellow cable, Plugged each of these into the positives that went to the old indis and it works fine.

And my MOT isnt until next July so got plenty of time until i have to faf abaout changing it

Don't mess about changing it, just disconnect the indicators from the tail lamp and fit normal indicators. Long as the brake light isn't affected by the indicators working it'll pass no problems.