micron exhaust

mac-1 · Post by **mac-1** » Sep 8th, '06, 17:02

hi people im not the most switched on person with things like this but i have tryed to remove the baffles from my micron exhaust on the bandit but when doing so i found in side the end of the baffle is spreed out like a Y shape this meens i cant pull it through and jams, the baffles im told are removable so can i do it with out messing it all up or and i just stupid and doing something wrong...lol. you dont have to answer that bit

AlexG · Post by **AlexG** » Sep 8th, '06, 17:53

Is the person who told you they are removeable a reliable source of information?

I don't have first hand experience (or 2nd, or 3rd for that matter) of Micron cans, but it might be easier to answer the question if you could take a photo or two...

mac-1 · Post by **mac-1** » Sep 8th, '06, 20:23

bridge fitted it and said the baffle can be removed but will give the bike flat spots and that i just needed to remove the screw and that is as far as i have got as the baffle will not pull all the way out

Post by **TLS-Moose** » Sep 8th, '06, 21:58

In which direction are you trying to take it out? have you tried the other way?

mac-1 · Post by **mac-1** » Sep 8th, '06, 23:14

OTHER WAY? iv tryed taking it out from the end of the can. the screw holds in in place..yeah? then just pull in out?

andy198712 · Post by **andy198712** » Sep 9th, '06, 10:08

hi means take the can off then slide it out the bottom?

good luck, best to rejet the bike too

Post by **TLS-Moose** » Sep 9th, '06, 13:41

Indeed I did