Anyone around with a welder ??

[Varcon]

Ok, i want to sort out my exhaust on my bike....make it a bit louder and better looking !

Its an all in one inclosed exhaust....so the plan is to cut the end from it, then cut the exhaust in half...remove baffle and weld the end back on....does anyone have a welder who can use it be willing to do this for me for some ££ ?? Or does anyone know a place where i could get this done ? Cheers !

[BEN!!!]

varcon hows you doing chap (its tzrman1984 from 125sb) anyways have you tied going to local garage and asking them i have done before and they have quite happily dot the work for me. failing that mate i have a welder and could have a look for ya geezer.

[Varcon]

Ah hello ! Loads of poeple on multpiple forums here with diff names !!

Yeah im gonna go up there today, and ask, if not then you might just come in handy !! Im asking at a garage run by one of my dads mate, so hopefully they should be able to sort me out !

[chris_1127]

if it's an alloy or stainless can you will need someone who can TIG weld (ac tig too if its alloy). You can arc stainless with the right rods (though i've never tried it) but doubt if the results would be great.
have you thought about cutting just the can off and fitting a slip on can?

[BEN!!!]

Ah hello ! Loads of poeple on multpiple forums here with diff names !!

Yeah im gonna go up there today, and ask, if not then you might just come in handy !! Im asking at a garage run by one of my dads mate, so hopefully they should be able to sort me out !

lol , yeah mate if i can help i will , i have arc welder i wont say im the greatest welder but ive done lots of it , for sub frames shock linkages etc

[Varcon]

Cool - well the garage did it for me for cheap, quite quick too ! But im not gonna stick with that can forever, the idea of at some point to cut the can off, and weld on a standard link pipe, then buy a can to fit ! So when i do that i will be sure to give you a call !