Help....Can anyone help fix my exhaust?

[Jewell]

hi peeps....

does anyone know a guy that can fix the hole on my down pipes on my nc30...cash in hand.....sod paying like 100 quid for a bike shop to take it off........smash it around,make the whole bigger and then say it needs a new full set but only they can get it for you etc etc as its a specialist part.....normal bike shop testicles

need a welder......

long shot i know but needs MOT.

thx.

[age]

nope

[furry]

Look in the Yellow Pages for Engineering places.... I know one here would do it for ?G20 no probs

[hilljd00]

Side Kick Exhaust Shop in Plymouth/Plympton.. Below ski lodge.

He welded a bit bk on my old exhaust for a fiver.

[BOSS]

If the holes not to big have you thought about using liquid metal and a piece of mesh.

If its a rust hole welding it could be a no no as the metal around the hole could be fatigued also.
You can get the liquid metal from K Coopers or hardware stores. Cant remember the name without going to my shed. I have used it and it works really well. its also heat resistant.
Comes in 2 tubes, 1 black, 1 red.

[Jewell]

nope

thx all.

[DynaMight]

It's easy to do mate, remove the whole system take it to any exhaust repair place and they should be able to weld new stainless steal collectors on for about £20.

I took it to this place in Willand, Did a perfect job. Haynes Manual have a good step by step guide how to remove it, As long as you bolts arent corroded and round off it's easy.

[Simeski]

Where abouts are you?.

[Whitetrash]

i couldo a fire-gum repair for youmate, get in touch

[RG_Soul]

my brother is a welder but he is in bournemouth

[gavin]

go to taunton fabucaion at galmington.
get some one in honda to do it

[CvPiper]

Just go to powerflow in taunton, it will cost fcuk all to repair, especially if you can have it off the bike to take into them.

[ZXR400Lee]

My Dad is a welder/steel fabricator/structural steel engineer. . I just had him patch up two holes in my downpipes at work, no more blowing!

You could hire a welder, buy some thin sheet metal, and a book from the libary and do it yourself .