South West Bikers | Motorcycle Forum

hi peeps....

does anyone know a guy that can fix the hole on my down pipes on my nc30...cash in hand.....sod paying like 100 quid for a bike shop to take it off........smash it around,make the whole bigger and then say it needs a new full set but only they can get it for you etc etc as its a specialist part.....normal bike shop testicles

need a welder......

long shot i know but needs MOT.

thx.

Look in the Yellow Pages for Engineering places.... I know one here would do it for ?G20 no probs

Side Kick Exhaust Shop in Plymouth/Plympton.. Below ski lodge.

He welded a bit bk on my old exhaust for a fiver.

If the holes not to big have you thought about using liquid metal and a piece of mesh.

If its a rust hole welding it could be a no no as the metal around the hole could be fatigued also.
You can get the liquid metal from K Coopers or hardware stores. Cant remember the name without going to my shed. I have used it and it works really well. its also heat resistant.
Comes in 2 tubes, 1 black, 1 red.

AGE996";p="28267 wrote:nope

thx all.

It's easy to do mate, remove the whole system take it to any exhaust repair place and they should be able to weld new stainless steal collectors on for about £20.

I took it to this place in Willand, Did a perfect job. Haynes Manual have a good step by step guide how to remove it, As long as you bolts arent corroded and round off it's easy.

Where abouts are you?.

i couldo a fire-gum repair for youmate, get in touch

my brother is a welder but he is in bournemouth

go to taunton fabucaion at galmington.
get some one in honda to do it

Just go to powerflow in taunton, it will cost fcuk all to repair, especially if you can have it off the bike to take into them.

My Dad is a welder/steel fabricator/structural steel engineer. . I just had him patch up two holes in my downpipes at work, no more blowing!

You could hire a welder, buy some thin sheet metal, and a book from the libary and do it yourself .